Hey everyone, I am playing with my VF2 and decided to build a custom kernel following this guide:
However, when booting it loads the kernel, then while continueing booting it gets stuck on this boot message:
starfive-dwmac 16040000.ethernet eth1: configuring for phy/rgmii-id link mode
I am pretty new to uboot so forgive my perhaps obvious question. I am using exact config from the guide, with KERNEL_VERSION replaced by my built kernel.
What am I doing wrong?
The old kernel still works as expected when I boot that.
I am using only NVME in terms of drives.
Would appreciate any advice